Archive for the ‘Progress’ Category

Head Light Panel

Saturday, March 2nd, 2013

The front bumper cover is almost ready to go back on.  The head light panel components were blasted, shot with etching primer, followed by a couple coats of Sem’s Rust Shield satin black.

photo-feb-23-1-55-51-pmphoto-feb-23-2-43-13-pmphoto-mar-02-11-51-04-am

Rear Bumper

Sunday, February 3rd, 2013

The rear bumper and side marker lights were installed.  New bumper reinforcement clips were sourced from Ebay.  The next project will be disassembling and restoring the original tail light assemblies.

photo-feb-02-1-39-51-pmphoto-feb-02-1-39-59-pmphoto-feb-16-12-16-15-pmphoto-feb-16-12-23-00-pm

Bumper Flex

Sunday, December 16th, 2012

These bumper covers are a real pain to work with.  I used a local shop to soda blast these and a few other pieces to make quick work of the stripping process.  A little work was required with the DA sander to smooth out some texture left by the blasting and to remove some left over paint in some areas.  Though this was the easy part.  The real challenge is making these pieces rigid enough so the primer and paint don’t crack when they’re flexed during handling and assembly.  The first attempt was unsuccessful so the majority of K36 primer (which included a flex additive by-the-way) was sanded off.

The next attempt will be to fasten some particle board to some of the mounting locations of the bumper in order to create a make-shift frame.  Next, in addition to PPG’s flex additive, the K36 will be thinned considerably in order to limit the build-up.

photo-sep-13-5-31-21-pmphoto-dec-01-3-00-45-pmphoto-dec-01-3-00-55-pm

YearOne Wheel Flares

Saturday, December 8th, 2012

YearOne’s wheels flares were fitted to the car. The second picture shows a side-by-side comparison of the original and aftermarket piece in respective order.  The original pieces are flexible urethane and the new pieces are rigid fiberglass.  Some trimming was required to get a good close fit.  One side had to be built up with a small amount of fiber glass.  Don’t expect these parts to be a bolt-on piece as some work is required.  The end result is a much cleaner appearance and certainly worth the extra effort.

imag0386imag0387imag0388photo-dec-01-9-59-34-am

Sunday, December 2nd, 2012